However, if removed, the disk drives must first be labelled to make sure that they are placed back in the same disk bays from which they were removed when reinstalled. In the Configuration Utility, select an adapter from the Adapter List. A value of zero allows unlimited time for an operation to complete and could result in the system hanging waiting forever if an operation fails. This allows the user to select disks on this channel to be members of a mirrored array. If one of the two disk drives used in the RAID 1 volume fails, the hotspare drive automatically replaces it in the volume and resync is immediately performed.
|Date Added:||4 July 2013|
|File Size:||53.42 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
LSI News Archives
The system BIOS assigns this value. Disk is not responding. Alternate CHS Mapping utilizes an alternate, possibly less efficient, mapping that may be required if a device is moved between adapters from different vendors. The Activate Array option enables you to reactivate an inactive array that has been added to a system. Provides general help information. This disk has been selected as the hotspare for the RAID array.
Allows the ability to prevent a hook on INT40, if required. When the volume has been fully configured, press C and select Save changes, then exit this menu to commit the changes.
Select your language
When you press Enter, the following fusiln-mpt appears: A disk may be disabled for the following reasons:. When the first disk is added, the utility will prompt you to keep existing data or overwrite existing data.
A bit hexadecimal value indicating the discovery status for the PHY or expander. Then reboot the system to clear memory.
VMware Compatibility Guide – I/O Device Search
The size of the array. Two settings are available:.
This option is only applicable to devices attached to adapter number zero fusion-mptt the boot list on non-BBS systems. Currently defined values are: This can increase storage capacity and performance by combining multiple disks into one logical volume. Otherwise, the old partitioning data will be reused. Activating an array also causes all the remaining arrays found on the physical adapter to be deactivated.
CHS Mapping includes two settings: You may decide to change these default values if there is a conflict between device settings or if you need to optimize system performance. For more information, see Section D.
However, this does not indicate a hardware malfunction. Adapter removed from scsu order. Function has range 0x00 – 0x7, 0 – 7 decimal. An 8-bit value mapped as follows: The type of array being created: There are several limitations when creating a RAID 1 volume:.
This message appears when fewer than four adapters are in the boot order and more adapters exist than are shown.
Enabled for illegal-configuration situations in which there is more than one array on this physical adapter. The Boot Alert setting can be either No or Yes. The Adapter Properties screen shown below allows you to view and modify adapter settings.
It is recommended that this field be set to the highest-priority SCSI identifier, which is 7. Note – If there is a global hot-spare disk on the controller to which you have moved the array, the BIOS checks when you activate the array to determine if the hot-spare is compatible with the new array.
Reset error counts for all Phys.