The BlackBox is a standalone decoder programmer. Indecently – probably servicing computers before you were born – then there is still a lot to learn. Sometimes you have to go into the device manager and force it to update the drivers, direct it to the driver file if you can. Thanks for response have done as suggested and no go keeps on reporting no driver found. It cannot find one on the internet either. If you have either ZTC system and wish to add computer control to your layout, an XPA and Hayes Compatible Modem may be a more cost effective solution than one of the purpose built interfaces. System specific limitations are also expressed in the Limitations section of each system below.
|Date Added:||23 October 2005|
|File Size:||36.81 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
I think I tried the FDTI site earlier on when the laptop was running W7 starter not tried with W7 HP, have downloaded again from the web site and will try again this afternoon.
So must be holding my mouth wrong again. Jan 20, Last Visited: We have a pretty good handle on what instructions each Lenz Command station should support. Jun 11, Last Visited: Nov 29, Last Visited: Peter, As the driver is for 64 bit systems, it won’t work on you 32 bit laptop.
W7 is very picky and won’t install “unsigned” drivers Maybe that will help point you in the right direction Tony Windows 7 bit will install unsigned drivers if you give it permission to do so.
Lenz USB – Interface | eBay
You cannot program decoders from a computer using the XPA, regardless of which system you have. We may add XBus Version 1. Hornby’s manuals warn against using their equipment with that of other manufacturers, so we expect some incompatibilities in this area. Viessmann has indicated intetface Commander’s built in USB port can only be used for updating the firmware and sending data to the commander, not for operating the device.
Feb 12, Last Visited: The Time Vortex near Melbourne, Australia. These ports can be used to connect one of the supported XpressNet computer interfaces, but it is unknown elnz this point what, if any, limitations exist when using this connection.
The following tools are available from the XpressNet menu when this connection is active click on the name to read more on each tool:. Thanks for response have done as suggested and no go keeps on reporting no driver found.
Jul 20, Last Visited: Just a thought as I us no expert on computers! The Compact is not available in North America. About this website Railpage version 3. Also I have a 32 bit laptop and this driver states it is for 64 bit.
The original NanoX DCC system supports operating equipment on a layout running trains and throwing switches and programming locomotives. It may be necessary to build an adapter to plug an XpressNet accessory into a Command Station from another manufacturer. XpressNet is a Command Bus developed by Lenz and used by: W7 is very picky and won’t install “unsigned” drivers Maybe that will help point you in the right direction Tony.
Lenz Li-USB-Ethernet Computer Interface
lena Quick Reply We’ve disabled Quick Reply for this thread as it was last updated more than six months ago. Installed drivers yet it also reports no driver found.
View mobile site Stats for nerds. The XpressNet specification available from the Lenz website specifies the electrical communications standards and command set needed for devices to communicate with the command station.
Hendo Are well wait for Lenz to update the software. It reports that interface not found though shows on Device manager. Windows 7 bit will not, unless you press F8 just when starting up to bring up the options menu.
The LocoMaus 2 does not support feedback. We should be able to use this to connect using one of the supported XpressNet computer interfaces, but the limitations of this port have not been determined.